Soltek 75MRN-L + nVidia 5900 Ultra: Fit Problem

A place for us all come together to discuss general topics of interest. Want to chat about music, movies, news, real life, or a game that we don't have a group for? This is the place.

Moderators: General Forum Moderators, Global Moderators

Soltek 75MRN-L + nVidia 5900 Ultra: Fit Problem

PostPosted: Thu Jul 20, 2006 5:13 am

User avatar
Futile Resistance
Posts: 1454
Joined: Tue Sep 07, 2004 10:44 pm
Location: FL
So I bought a "broken" 5900 ultra off eBay (by accident actually; fortunately it turns out it works just fine).

I'm trying to put that into my backup media PC (which friends come over and LAN every now and then) however with the layout of the Soltek 75mrn mobo, the memory module "tabs" block the very end of the 5900 from seating down all the way in the AGP slot.

I was wondering if it was possible to "saw off" half of the tab (a vertical saw, not horizontal). This should allow the vid card to seat down all the way.

If so, what tool should I use?

Thanks all

PostPosted: Sat Jul 22, 2006 3:13 am

User avatar
Futile Resistance
Posts: 1454
Joined: Tue Sep 07, 2004 10:44 pm
Location: FL
Alright.

Going to buy an exacto knife this weekend and do a little experimenting! :D

PostPosted: Sat Jul 22, 2006 7:02 am

User avatar
Stracius
Posts: 1471
Joined: Wed Nov 17, 2004 4:02 pm
Location: under the starry night sky
Not entirely sure how circuit boards react to cutting and force, but you might try scoring it as they do with glass. Just use the knife to make a good, somewhat deep cut, and then snap it off.

Otherwise, maybe a small hacksaw... Good luck and let us know how it goes :)

PostPosted: Sat Jul 22, 2006 5:47 pm

User avatar
Padishar
Posts: 1713
Joined: Wed Sep 01, 2004 11:15 pm
Location: Next Door
Honesty, I would heat the blade up and slowly melt a couple small slices thru it, then when you get a decent little set of grooves, snap it off.

As direct pressure force from cutting/sawing increases the chance of doing 'accidental' damage to your board.

Sometimes in need.... sometimes in experimentation..... Done all kinds of unmentionable things to MB's in past. :sweat:

PostPosted: Sat Jul 22, 2006 6:54 pm

User avatar
Lazlo Hollyfeld
Posts: 186
Joined: Wed Sep 01, 2004 11:20 pm
Location: the basement
As direct pressure force from cutting/sawing increases the chance of doing 'accidental' damage to your board.
true....

something else to consider would be using a dremel tool. you wouldn't have to stress the board at all.

PostPosted: Sat Jul 22, 2006 9:52 pm

User avatar
Futile Resistance
Posts: 1454
Joined: Tue Sep 07, 2004 10:44 pm
Location: FL
Lazlo Hollyfeld wrote: something else to consider would be using a dremel tool. you wouldn't have to stress the board at all.
Hrm... Time to hit up the local Home Depot then. Thanks, sounds like the best way to do it. :thumb:

Return to “General Discussions”